Feedback on Curb cuts

Can you provide a simple diagram depicting the various parameters?

Curb inlets should include information/details about saw cuts for flow redirection, CIP 'riffles' for energy dissipation, etc. Some of this can be seen in the images you have included, but it should be discussed (if any data/literature is availab...Curb inlets should include information/details about saw cuts for flow redirection, CIP 'riffles' for energy dissipation, etc. Some of this can be seen in the images you have included, but it should be discussed (if any data/literature is available).More

Some of the pictures, while aesthetically pleasing, depict inlet configuration which have questionable efficacy (e.g. narrow curb openings, grading issues at curb inlets, etc.). Curb inlet grading and cross fall through a curb inlet should receiv...Some of the pictures, while aesthetically pleasing, depict inlet configuration which have questionable efficacy (e.g. narrow curb openings, grading issues at curb inlets, etc.). Curb inlet grading and cross fall through a curb inlet should receive special attention and have it's own section on this page. -BTMore

Title of this page should be 'Curb Inlets' (not 'Curb Cuts' to be consistent with the title of the link on the home page. 2nd line - add a hyphen between 'well' and 'suited' and between 'cross' and 'slope' The last sentence that reads 'this might...Title of this page should be 'Curb Inlets' (not 'Curb Cuts' to be consistent with the title of the link on the home page. 2nd line - add a hyphen between 'well' and 'suited' and between 'cross' and 'slope' The last sentence that reads 'this might be the local topography...parkland?' is odd and seems either incomplete or should not include a question mark. 3rd line - Change the word 'As' to 'Since' to start the sentence. 4th line- 'OPSD' should include the full spelling of the acronym or should be tied to a link that explains the acronym. Sizing section, 1st line - Change text from 'The inlet must be of width." to 'The inlet must be of the width that is defined by the following formula'. In the formula under Sx - Add a hyphen between 'cross' and 'slope' In the 3rd line of the second formula descriptors - Add a hyphen between 'cross' and 'slope' Throughout the text on this page use 'Curb Inlet' in place of 'Curb Cut' for consistency with the title of the page/home page. The page would benefit from some discussion related to trash grates along with some examples. There should also be a recommendation to avoid squared-off edges since these tend to get damaged by snow plows.More

I have already discussed with you in person, but key element of a curb inlet is the slope dropping down into the feature. This needs to be relatively steep while meeting municipal safety standards, otherwise sediment and debris build up and block...I have already discussed with you in person, but key element of a curb inlet is the slope dropping down into the feature. This needs to be relatively steep while meeting municipal safety standards, otherwise sediment and debris build up and block the flow. Some of the examples shown above do not seem to be steep enough based on my experience.More