Line 1: |
Line 1: |
| <poem> | | <poem> |
− | Curb cuts are a form of BMP [[Inlets|inlet]]. | + | Curb cuts are a form of LID/BMP [[Inlets|inlet]]. |
| They are well suited to retrofit scenarios and to collect runoff from catchments with relatively gentle longitudinal slope, and/or a greater cross slope. This might be the local topography of a parking lot or a piece of parkland? | | They are well suited to retrofit scenarios and to collect runoff from catchments with relatively gentle longitudinal slope, and/or a greater cross slope. This might be the local topography of a parking lot or a piece of parkland? |
| As this inlet width is directly proportional to longitudinal slope; the required curb cut width increases rapidly on steeper roads. | | As this inlet width is directly proportional to longitudinal slope; the required curb cut width increases rapidly on steeper roads. |
Line 26: |
Line 26: |
| {{#widget:WolframAlpha|id=664012476f5d9635d57cd58920e763e6}}</div> | | {{#widget:WolframAlpha|id=664012476f5d9635d57cd58920e763e6}}</div> |
| | | |
− | To completely capture linear flow travelling along a gutter perpendicular to a curb inlet, the inlet must be of width:: | + | To completely capture linear flow travelling along a gutter perpendicular to a curb inlet, the inlet must be of width<ref>U.S. Department of Transportation, Federal Highways Administration. 2013. “URBAN DRAINAGE DESIGN MANUAL.” https://www.fhwa.dot.gov/engineering/hydraulics/pubs/10009/10009.pdf.[[File:USFHWA 2009.pdf|view here]]</ref>:: |
| <math>W_T=0.817Q^{0.42}S_{0}^{0.3}\left (\frac{1}{nS_{x}}\right)^{0.6}</math> | | <math>W_T=0.817Q^{0.42}S_{0}^{0.3}\left (\frac{1}{nS_{x}}\right)^{0.6}</math> |
| | | |
Line 43: |
Line 43: |
| *''W'' is the available curb cut width (m)}} | | *''W'' is the available curb cut width (m)}} |
| | | |
− | Where the curb cut width is constrained and a greater flow into the BMP is desired, the effective cross slope may be increased by adding a depressed apron. | + | Where the curb cut width is constrained and a greater flow into the BMP is desired, the effective cross slope may be increased by adding a depressed apron. |
| | | |
| ==Example== | | ==Example== |
Line 59: |
Line 59: |
| {{:Curb cuts: Gallery}} | | {{:Curb cuts: Gallery}} |
| ---- | | ---- |
− | [[category: modeling]] | + | [[category: Calculations]] |