Difference between revisions of "Pretreatment features"

From LID SWM Planning and Design Guide
Jump to navigation Jump to search
m
m
Line 18: Line 18:
 
{{plainlist| 1=Where:
 
{{plainlist| 1=Where:
 
*''Q'' = Design flow rate (m³/s)
 
*''Q'' = Design flow rate (m³/s)
 
+
*''V<sub>f</sub> = Volume of forebay (m³).}}
  
  

Revision as of 19:47, 5 April 2018

Without a forebay (top) the flow is concentrated around the inlet, potentially causing erosion and not optimally spread for infiltration; A three sided forebay (centre) with a level spreader on all sides will distribute the water and reduce the energy, sediment will collect in the pad of the forebay (shown darker); In a narrow cell, the forebay may extend across the whole facility (bottom).

Forebays are a form of pretreatment for open inlets such as curb cuts. Energy of the incoming flow is dissipated, causing suspended particles to drop out of the water. These accumulated particles/sediment can then be easily swept or vacuumed during routine maintenance and doesn't end up clogging downstream filter media or material. A well designed forebay will also spread the flow somewhat, reducing erosion around the inlet. One effective way of achieving this is by surrounding the pad with some form of level spreader on all sides. The level spreading could be a sharp crested weir in metal or concrete, or be more like a soft edged check dam.

The required volume for a small forebay, serving up to 2 Ha (Vf, m³), may be calculated as:

Where:

  • Ac = The area of the catchment (m²),
  • R = The capture efficiency (suggest 0.8),
  • Lo = The sediment loading rate (m³/Ha/yr), and
  • Fc = The cleanout frequency (yrs)

The area of the forebay (A<subf) designed for 80 % capture efficiency (i.e. R = 0.8) may be calculated as:

Where:

  • Q = Design flow rate (m³/s)
  • Vf = Volume of forebay (m³).



Gallery[edit]