Grain size analysis

This method of determining design infiltration rate is only approved for sandy native soils with d₁₀ between 0.1 - 2.5 mm (i.e. soils to which the Hazen formula is applicable).

This method must not be applied within areas of fill or in regions where hydraulic conductivity is controlled by vertical fractures in the soil matrix.

Procedure

1. Collect soil samples for each defined soil layer below the bottom of the proposed infiltration facility. Layers must be evaluated to the following depths, depending upon facility type:
   • For bioretention facilities, analyze each defined layer below the proposed facility bottom to a depth of at least 3 times the maximum ponding depth, but not less than 1 m.  
   • For permeable paving, analyze each defined layer below the proposed facility bottom to a depth of at least 3 times the maximum depth of water within the base course, but not less than 1 m.  
   • For other types of infiltration facilities serving drainage areas up to 4 Ha, analyze each defined layer below the proposed facility bottom to a depth of at least 2.5 times the maximum depth of water in the facility, but not less than 3 m.  
2. Submit the soil samples to a certified soil testing laboratory for grain-size, or particle-size distribution analysis according to ASTM D422.

Data Analysis

NB: The Hazen formula method of estimating soil permeability based on grain size distribution analysis is only suitable for soils with d₁₀ between 0.1 and 2.5 millimeters . The soil permeability value estimated using the Hazen method can be considered to be the measured infiltration rate of the soil, f, in mm/h

$f=C\cdot {\left(d_{10}\right)^{2}}$

Where:

• d₁₀ = the soil particle diameter for which 10% of all soil particles are finer (smaller) by weight (mm), median value of all samples tested.
• C = is a shape factor (see below)

Shape factors (C) to yield K in mm/hr
Very fine to fine sand	144000
Medium to coarse sand	288000

A parameter that describes the capability of a medium to transmit water.

The rate at which stormwater percolates into the subsoil measured in inches per hour.

Mineral particles which are smaller than 2 mm, and which are free of appreciable quantities of clay and silt. Coarse sand usually designates sand grains with particle size between 0.2 and 0.02 mm.

The slow movement of water into or through a soil or drainage system.

Penetration of water through the ground surface.

The technique of removing pollutants from runoff as it infiltrates through the soil.