Difference between revisions of "Dry ponds: TTT"
Jump to navigation
Jump to search
Jenny Hill (talk | contribs) |
Jenny Hill (talk | contribs) |
||
Line 1: | Line 1: | ||
{{Clickable button|[[File:TTT.png|400 px|link=http://www.sustainabletechnologies.ca/wp/low-impact-development-treatment-train-tool/]]}} | {{Clickable button|[[File:TTT.png|400 px|link=http://www.sustainabletechnologies.ca/wp/low-impact-development-treatment-train-tool/]]}} | ||
[[File:Storage TTT.png|thumb|[[Dry ponds]] are found in storage element in the LID TTT.]] | [[File:Storage TTT.png|thumb|[[Dry ponds]] are found in storage element in the LID TTT.]] | ||
− | [[File:Pond curves.png|thumb|The largest area is level 0 m | + | [[File:Pond curves.png|thumb|The largest area is at the top, level 0 m; each subsequent lower depth has a smaller area]] |
Dry ponds are a storage element in the Treatment Train Tool. | Dry ponds are a storage element in the Treatment Train Tool. |
Revision as of 15:09, 29 September 2017
Dry ponds are a storage element in the Treatment Train Tool.
Stage Storage | |
---|---|
Name | Important to have a unique name, to connect it with the catchment area |
Storage type | Dry detention ponds |
Bottom elevation (m) | This is important to correspond with other components, e.g. when the overflow is coupled to another BMP within a treatment train |
Maximum depth (m) | |
Lined/unlined | Unlined (ideally) |
Underlying soil | Choose from five, where sandy soils will drain more quickly. |
Evaporation factor | ? |
Suction head (mm) | ? |
Saturated conductivity (mm/hr) | ? |
Initial soil moisture deficit (fraction) | ? |
Curves | |
The Curves table is designed to accommodate the side slopes. The top line begins at 0 m, with subsequent depths in the following lines. |