Open main menu

LID SWM Planning and Design Guide β

Reservoir aggregate

Revision as of 20:11, 5 March 2018 by Jenny Hill (talk | contribs)

For advice on decorative surface aggregates see Stone

Gravel used for underdrains and underground infiltration structures should be 20 - 50 mm, uniformly-graded, clean (maximum wash loss of 0.5%), crushed angular stone that has a void ratio of 0.4[1].

The uniform grading and the angularity are important to maintain pore throats and clear voids between particles. (i.e. achieve the void ratio). The clean wash to prevent rapid accumulation of fines from the aggregate particles in the base of the reservoir.

Gravel with structural requirements should also meet the following criteria:

  • Minimum durability index of 35
  • Maximum abrasion of 10% for 100 revolutions and maximum of 50% for 500 revolutions

  1. Porosity of Structural Backfill, Tech Sheet #1, Stormtech, Nov 2012, accessed 16 October 2017