Difference between revisions of "Notation"

From LID SWM Planning and Design Guide
Jump to navigation Jump to search
m
m
Line 56: Line 56:
 
:time (usually in hrs)
 
:time (usually in hrs)
  
V;
+
;V
 
:Volume (usually in m<sup>3</sup>)
 
:Volume (usually in m<sup>3</sup>)
  

Revision as of 16:28, 6 November 2017

Ac
Area of the catchment, whole contributing drainage area (usually in m2).
Ap
Area of the practice e.g. footprint area of a bioretention cell (usually in m2)
d
Depth e.g. of an infiltration practice (units of length, usually m)
h
height (units of length)
L
Length, e.g. of a reach, channel or swale (usually in m)
m
run of side slopes in channel cross sections (length, but usually expressed as a ratio in relation to rise. e.g. side slopes = 1:3, so m = 3)
n
Manning's coefficient (unitless) Note: for clarity porosity is being expressed as 'void ratio' and sharing the notation VR
P
Perimeter of infiltration practice or swale x-section (m)
q
Infiltration rate in (length per time, usually mm/hr)
q'
Infiltration coefficient in (length per time, usually mm/hr) after application of safety correction factor (SCF)
Qp
Peak flow in units of volume per time (e.g. m3/s)
R
Ratio of catchment (Ac) to the practice footprint area (Ap). syn. I/P ratio. For green roofs (and often permeable paving systems) this will be 1:1. In bioretention it may be 15 or 20 to 1.
Ra
Existing rise of swale gradient (length, usually m)
Rb
Rise of compensation gradient for an enhanced swale (length, usually m)
RVCT
Runoff volume control target (as outlined by MOECC, units are mm)
S0
Longitudinal slope (m/m, i.e. dimensionless)
Sx
Cross slope (m/m, i.e. dimensionless)
SCF
Safety correction factor (dimensionless)
t
time (usually in hrs)
V
Volume (usually in m3)
VR
Void ratio, as usually applied to aggregates and yard materials. In this guide, it is also applied to native soils in lieu of porosity (unit for both are vol/vol, i.e. dimensionless)
y
Depth of water (length, usually m or sometimes mm)