# Difference between revisions of "Flow through an orifice"

From LID SWM Planning and Design Guide

Jenny Hill (talk | contribs) m |
Jenny Hill (talk | contribs) m |
||

Line 1: | Line 1: | ||

− | Orifices are simply holes which restrict the flow of water. They may be used at the bottom end of an LID practice to add some [[flow control]] | + | Orifices are simply holes which restrict the flow of water. They may be used at the bottom end of an LID practice to add some [[flow control]]: |

<math>Q= B\times C_{d}\times A_{o}\sqrt{2\cdot g\cdot h}</math> | <math>Q= B\times C_{d}\times A_{o}\sqrt{2\cdot g\cdot h}</math> |

## Latest revision as of 19:57, 17 March 2019

Orifices are simply holes which restrict the flow of water. They may be used at the bottom end of an LIDLow Impact Development. A stormwater management strategy that seeks to mitigate the impacts of increased urban runoff and stormwater pollution by managing it as close to its source as possible. It comprises a set of site design approaches and small scale stormwater management practices that promote the use of natural systems for infiltration and evapotranspiration, and rainwater harvesting. practice to add some flow control\[Q= B\times C_{d}\times A_{o}\sqrt{2\cdot g\cdot h}\]

Where:

*B*is the clogging factor (between 0.5 (for matured installation) and 1 (for a new perfectly performing orifice)),*C*is the coefficient of discharge (usually 0.61 for a plate, or 0.8 for a pipe),_{d}*A*is the area of the orifice (m_{o}^{2}),*g*is acceleration due to gravity = 9.81 m/s^{2}, and*h*is the head of water over the centre of the orifice (m).