Curb cuts

From LID SWM Planning and Design Guide
Revision as of 01:13, 29 September 2017 by Jenny Hill (talk | contribs)
Jump to: navigation, search


To completely capture linear flow travelling along a gutter perpendicular to a curb inlet, the inlet must be of width:\[W_T=0.817Q^{0.42}S_{0}^{0.3}\left (\frac{1}{nS_{x}}\right)^{0.6}\]

Where the intention is to capture only a proportion of the flow, the ratio of flow entering the curb inlet may be calculated:\[R_c=1-\left ( 1-\frac{W}{W_T} \right )^{1.8}\]


A curb cut of 3 m is proposed as an inlet for an offlineRefers to a system that when full, stormwater will bypass the practice. Offline systems use flow splitters or bypass channels that only allow the water quality volume to enter the facility. This may be achieved with a pipe, weir, or curb opening sized for the target flow, but in conjunction, create a bypass channel so that higher flows do not pass over the surface of the filter bed. bioretentionA shallow excavated surface depression containing prepared filter media, mulch, and planted with selected vegetation. cell receiving runoffThat potion of the water precipitated onto a catchment area, which flows as surface discharge from the catchment area past a specified point.Water from rain, snow melt, or irrigation that flows over the land surface. from an adjacent roadway. The gutter and the curb are made from smooth concrete with Manning's 'n' = 0.013. The x-slope is 3% and the longitudinal slope of the road is 2%. The design storm produces flow of 0.08 m3/s.

The width of inlet to capture 100% of this flow is:\[W_T=0.817\times(0.08)^{0.42}\times(0.02)^{0.3}\left (\frac{1}{(0.013)\times(0.03)}\right)^{0.6}\]

Curb cuts Gallery